Sunday, August 11, 2013
Someone emailed earlier asking if I had a how to on how to fold over a clip using some titanium or stainless and I only had written ones so I thought I'd show a simple way anyone can just do a couple if you want to play around. Just don't burn yourself. No long sleeves or if you do wear them have cuffs on them so it is not flapping around on you. Get the long hair tied back. Don't have anything flammable around that you might lay a hot clip on to burn the place up and stuff like that. Remember measure twice, bend once. Look and fold only when hot and if your timing gets messed up you can't hurt anything to heat it again. Start over if you need. Keep the scraps for learning until its so small you can't make it fold over anymore.
On many of the issues regarding factory clips I can save you some time getting too carried away unless you are a glutton for punishment like I was and like learning the hard way. I will caution again even though I put it in a bubble in the video, going thicker can sound nice but bending it is an art, and if you go too thick the factory screws won't grab and some manufactures cut things pretty dang close as you know. So sometimes just bumping the thickness .005 of an inch is all it takes to mean the screws no longer grab to tighten down. So unless you want to get into cutting and custom making your own screw lengths to fit you want to stick with as close to the factory equipment as possible.
Below is me on my day off but after getting this email I liked the idea and thought you know, I can probably help with that. So let me know how I did and if you try some hey bring em on over and show me. :-)