This arrived today from a customer wanting to have me make a clip that actually buried the folder. This is the first time I've been turned on to this model as it was one of those that flew below my radar. I find it rather to my liking and now on my want list. This one has the window breaker on the end so the clip request was that it bury the knife making the clip do that as much as possible while not interfering with the carbide tip. Its a tall order but I pulled it off and on the first try! Go figure! Love the color! This folder also has a safety cutting blade for removing seat belts (or gutting a deer :-) ) Anyway, I figured since it was flying below my radar and I'm a knife nut that it is possible some of my viewers here have not seen it either so I will post this first set now and get more up tomorrow once I blast this clip and finish the job. I'll post up a shot of that second blade on this one then too. Thanks for looking
STR
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
.JPG)
7 comments:
Hello there,
I just tried to post a comment but I'm not sure if it went through...
I was wondering if you have deep pocket clips that would fit a Spyderco Chokwe. If so, how do I proceed with a purchase?
Keep up this awesome work, it's quite impressive!
Thank you,
J/
I received both but allowed the one since they say the same thing just about. I believe you also asked on blade forums as I just answered this on that message thread. I need to refer you to the work order form questions from the second post found here. http://www.bladeforums.com/forums/showthread.php/525771-Low-Rider-Pocket-Clip-info-mailing-instructions
Now that you made a custom clip for the Benchmade Triage, can I order one and have it sent to me?
Thanks, Mike
This model needs a lot of adjustments to properly fit the mount plate so it kind of weaves in there not blocking the lanyard hole and so there is no or very little overhang not interfering with the additional equipment built into the design parameter of the folder..These factors make this one a model that I will always be a specialty one off clip that would require the folder be mailed to me. Sorry.
STR
Where do I mail it to, and what is the cost?
Thanks,
Mike
Hi Knappy. Simply go here, use your keypad to fill out, hit control shift and P to print it out and simply mail with the folder TO STR 4006 Woodville Rd. Bartlesville, OK 74006 Thanks
http://strknifeworks.com/order.php
Oh and you can send it to me via the send button too after printing if you like. Thanks
STR
Post a Comment